Fork seal replacement

(1/5) > >>

NevsMate:
Hi Guys n Gals,

Looking for guidance, I am looking to replace both fork seals, but I'm planning NOT to do the 'full' strip down, specially on the left leg.

As I do not have the special socket for the left leg, how do I measure the correct oil Height (and what is the height) as the fork won't be collapsed?

Cheers

Geoff.

Valker:
Pour it in by volume rather than height. I don't currently remember what that volume should be.

RonW:
"I do not have the special socket for the left leg,"


Some notched a heating element wrench for a hot water heater, Home Depot.




Factory specs. (some other member's photo).

Speedy Coop:
Use O.E.M. seals for best results. I learned the hard way.

RonW:
"Looking for guidance, I am looking to replace both fork seals,"


The Right fork has only 4 internal parts when you get in there excluding the oil seal assy. (Enlarge graphic otherwise it's blurry.)

Navigation

[0] Message Index

[#] Next page