How to ? Sidestand switch bypass

<< < (2/2)

WintrSol:
OK, that makes sense, now. You could just unplug it, so it thinks the stand is always down and splice the wires so it's always up. You could cut the cable from the switch to the harness and jumper the wires near the harness connector, under the frame where the seat mounts, then just discard the switch and the rest of the cable. Look at page 19-16 of the service manual.

bill-jr:
Quote from: WintrSol on August 19, 2025, 11:41:51 AM

OK, that makes sense, now. You could just unplug it, so it thinks the stand is always down and splice the wires so it's always up. You could cut the cable from the switch to the harness and jumper the wires near the harness connector, under the frame where the seat mounts, then just discard the switch and the rest of the cable. Look at page 19-16 of the service manual.

Thanks . . .

Navigation

[0] Message Index

[*] Previous page