Need help with pegs!

[BIG--T]

I want to order a some longhorn offset pegs. Can someone tell me the diameter of the engine guard? 1 1/4"?

Thanks

[hal47]

I have the interstate but think their all the same, the bottom part down by the ex. is 1 inch,the round part around the timing cover is 1 1/8. the top tube is not round tho,so youmay have to put a piece of rubber under it. hope this helps.

[MNBill]

I put a piece of copper water pipe under mine, held toght, would not scratch

[BIG--T]

Thanks all, I found out after I posted. Yes it's 1 1/8" and I was wanting to put a longhorn offset peg there and already ordered one.