Valkyrie Riders Cruiser Club
June 22, 2025, 04:09:55 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 17
Pages: [1]   Go Down
Send this topic Print
Author Topic: Swede down!  (Read 3388 times)
Whistler
Member
*****
Posts: 1234


Kansas VRCC State Rep., Formerly known as EngEmt

North Newton, Kansas


« on: July 08, 2015, 12:12:45 AM »

Larry Olson went down yesterday in Colorado! Out in the middle of no where, 20 minutes to get to a signal to call 911. He will be okay
, but has a lot of healing to do. He is currently in St. Mary's in Grand Junction. The bike is not good but we need to get it home and see. Prayers are welcome!
Logged

Brewer
Member
*****
Posts: 331

Denver, CO


« Reply #1 on: July 08, 2015, 04:41:57 AM »

Whistler, Prayers sent. What else can we help with?
Logged

Brewer - it is a hobby
JimmyG
Member
*****
Posts: 1452


Tennessee


« Reply #2 on: July 08, 2015, 08:49:37 PM »

Awful. Prayers sent. What can we do to help?
Logged
Whistler
Member
*****
Posts: 1234


Kansas VRCC State Rep., Formerly known as EngEmt

North Newton, Kansas


« Reply #3 on: July 10, 2015, 12:47:00 PM »

I'm a bit behind here trying to work on to many electronic gadgets! Larry is currently in ICU he had a reaction to the pain meds and procedures causing him to stop breathing, that was Wednesday. They were able to get him going again, but that is how he ended up in ICU. Probably there another day yet, then to another room for who knows how long. His son is going today to get the bike it is apparently 250 miles south of Grand Junction, which is crazy, we were only 90 miles from GJ to start with. He is resting fairly comfortably, but they want to get him moving around. That will be a bit difficult for him. Shoulder surgery has been postponed till he gets home.
Logged

Pages: [1]   Go Up
Send this topic Print
Jump to: