|
Title: ROX 2" RISERS Post by: texasmark on March 31, 2018, 04:35:36 PM Has anyone installed these ROX 2" risers? I do not want to mess with extending any wires or cables, and want the bars to clear the tank on full swing. Keeping stock bars, so no replies needed about swapping bars. Thanks.
https://www.jpcycles.com/2014-honda-valkyrie-gl1800c/handlebar-risers (https://www.jpcycles.com/2014-honda-valkyrie-gl1800c/handlebar-risers) Title: Re: ROX 2" RISERS Post by: bscrive on March 31, 2018, 04:38:04 PM I have heard that a few people have put them on without any issues all they had to do was cut some cable ties in the front headlight area to get a little bit extra wire.
Title: Re: ROX 2" RISERS Post by: texasmark on March 31, 2018, 06:23:22 PM Thanks, am going to get a pair.
Title: Re: ROX 2" RISERS Post by: bscrive on March 31, 2018, 06:42:10 PM One fellow I know on the F6C Forum put on 3" Rox risers. He just had to relocate some wiring to get the needed length.
Here is a picture of the 2" Rox risers installed on a guy's Valk. (https://s19.postimg.org/z8p6vfhsv/2_Rox_Risers.jpg) (https://postimg.org/image/z8p6vfhsv/) Title: Re: ROX 2" RISERS Post by: PAVALKER on April 08, 2018, 03:50:12 PM I have the 2inch Rox and a local guy went to 3in Rox. Much better.
Title: Re: ROX 2" RISERS Post by: Farther on August 11, 2018, 03:26:58 PM Any photos of the install?
Title: Re: ROX 2" RISERS Post by: PAVALKER on August 18, 2018, 12:57:03 PM Any photos of the install? There were some on the F6C Forum and Facebook page as well I believe. |