Valkyrie Riders Cruiser Club

General => 1500 Tech Board => Topic started by: Jim Ross on June 07, 2009, 05:04:04 PM



Title: timing belts
Post by: Jim Ross on June 07, 2009, 05:04:04 PM
I know the recommended change is at 50K miles or thereabouts, but has anyone found a GREAT price (less than $45 ea) for these oem belts?
How about Gates or Napa...is the quality equal to oem?
I once heard of an older GoldWing going over 90K before changing the belts....but I would not stretch it quite that far, better safe than sorry!


Title: Re: timing belts
Post by: MP on June 07, 2009, 05:12:06 PM
I thought it was 100,000 miles.


Title: Re: timing belts
Post by: alph on June 07, 2009, 05:14:01 PM
You know, I’ve seen those belts on Ebay and have often thought about getting them.  Question is, are they junk? Should I just order some from the local (rip me off again) Honda shop?

Al.


Title: Re: timing belts
Post by: Valker on June 07, 2009, 05:20:59 PM
NAPA sells them MUCH cheaper than a dealer. The manual says to inspect the timing belts at 100K.


Title: Re: timing belts
Post by: Scott from FL, now in Maine on June 07, 2009, 05:24:35 PM
http://www.jkozloski.com/generic_parts.htm (http://www.jkozloski.com/generic_parts.htm)

 8)


Title: Re: timing belts
Post by: R J on June 07, 2009, 05:26:12 PM
NAPA sells them MUCH cheaper than a dealer. The manual says to inspect the timing belts at 100K.


My original belts were replace at 140,000.  I'll be putting on the 2nd set in another 40,000 miles.   I used the NAPA belt on the 1st one, will probably use them again.

http://www.jkozloski.com/generic_parts.htm (http://www.jkozloski.com/generic_parts.htm)


Title: Re: timing belts
Post by: Dave Weaver on June 07, 2009, 05:31:35 PM
I just replaced mine about a month ago, and they had 36,000 miles on them.  I replaced them due to age, 12 years, and not mileage.  I used the Gates belts and quality seems about same as OEM.  The originals were probably OK, but what price is peace of mind?


Title: Re: timing belts
Post by: valk2128 on June 07, 2009, 06:17:10 PM
I replaced mine about a month ago with NAPA belts and they are very good. 
Replaced due to age (1998 Valkyrie) and not mileage (only 16,300 miles, still breaking her in).


Title: Re: timing belts
Post by: franco6 on June 07, 2009, 09:20:46 PM
thanks Dave. i bought those gates on e bay too and was wondering if it was a wise choice.have not heard from any one about them.when i get a minute i ll install them ,was waiting to get the 6 trigger wheel but i don t think i llgo that route. the valk has 50,750 miles .no rush, just peace of mind!


Title: Re: timing belts
Post by: Daniel Meyer on June 08, 2009, 05:07:05 AM
These belts are not fragile. Inspect them at 100k...if there's wear on the teeth or the backs replace them. If there's wear on the backs replace the tensioners too.