|
Title: Torque Loops with New Torque Master Pipes installed on my F6C 2014 Post by: rudymsmith on June 11, 2017, 12:41:42 PM Just got everything installed and back together - at 1800 miles I found lots and lots of loose nuts in bolts around the bike - YIKES!
Torque loopz and Torque Master pipes Install didn't require as much swearing as when I installed on my F6B. I had to remove the left side hard case because the bracket wasn't lining up just right. Make sure you do a dry run before you start cutting - measure three times and cut ONCE. I used a little exhaust sealer for good measure. I did the "adaptive" reset by: starting the Valkyrie with no throttle and running it till the fans cycled on AND off - then I shut it down; and let it cool off. I did a restart about an hour later and took it for a long highway adaptive ride. The sound is not too loud, no drone just sweet rumble. I can't say I felt any power gains - yet. Rode her like a new toy. Title: Re: Torque Loops with New Torque Master Pipes installed on my F6C 2014 Post by: goldstar903 on June 11, 2017, 01:24:24 PM Cool! Do you think it's worth the money sound wise. I know that it's a modest HP (~3) increase, but I imagine that a re-flash should get you more. :-\
Title: Re: Torque Loops with New Torque Master Pipes installed on my F6C 2014 Post by: rudymsmith on June 11, 2017, 03:01:27 PM I like the sound - a little more authority without being obnoxious. None of the drone.
I will hold off on the guhl reflash until warranty runs out. :police: Title: Re: Torque Loops with New Torque Master Pipes installed on my F6C 2014 Post by: Robert on June 11, 2017, 05:29:39 PM I am curious about the adaptive reset, are you sure that is the way to do it?
Title: Re: Torque Loops with New Torque Master Pipes installed on my F6C 2014 Post by: lazos valk on June 11, 2017, 05:39:57 PM Nice. Any pics or sound bites.
Title: Re: Torque Loops with New Torque Master Pipes installed on my F6C 2014 Post by: rudymsmith on June 12, 2017, 07:53:02 AM I am curious about the adaptive reset, are you sure that is the way to do it? I repeated the procedure as I learned on the F6B forum - and it works at least as far as I can tell.Also the cold hesitation seems to be gone. Title: Re: Torque Loops with New Torque Master Pipes installed on my F6C 2014 Post by: GA VALK on June 15, 2017, 04:47:18 PM How many baffles do you have in?
Title: Re: Torque Loops with New Torque Master Pipes installed on my F6C 2014 Post by: rudymsmith on June 17, 2017, 10:49:54 AM I do not have any baffles that i am aware of... just the torque loops and the torque master slip ons. Cats gone.
Title: Re: Torque Loops with New Torque Master Pipes installed on my F6C 2014 Post by: GA VALK on June 19, 2017, 02:59:45 PM And the sound is great!
Title: Re: Torque Loops with New Torque Master Pipes installed on my F6C 2014 Post by: bscrive on June 19, 2017, 05:25:04 PM WE NEED PICS!!!!!
|