Valkyrie Riders Cruiser Club
July 11, 2025, 05:47:29 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Pages: [1]   Go Down
Send this topic Print
Author Topic: I/S pod screen install instructions  (Read 1831 times)
Fawkesy
Member
*****
Posts: 7


« on: November 12, 2009, 08:43:05 AM »

I have seen a few I/S owners who have installed chrome screens (That match the rad chrome screen accessory) in thier pods.
Does anyone have instructions? I have screen, but do I silicone them in, heat the screen and melt it to the inside of the pod, etc.?
Thanks.
Logged
Baloo
Member
*****
Posts: 181


Rimouski, Canada


« Reply #1 on: November 12, 2009, 12:16:27 PM »

I installed mesh in my I/S pods. I used hot glue to hold them in. Held pretty well after 2 years.
Logged

Never ride any faster than your guardian angel can fly...
DFragn
Guest
« Reply #2 on: November 12, 2009, 05:24:50 PM »

I cut mine from 5" gutter screen and attached with the integral screws. For the upper vent intake it's just sandwiched in there.

There's a aluminum edge cap on the gutter screen. To do it the way I did you need every available inch of it. The length long edge cover is just pressed on and can be opened up and removed with a screwdriver.

A few bends to conform and it's done.

No messy silicone adhesives or glue. Screwing & sandwiched would allow easy changeout should it ever be necessary.





Logged
Pages: [1]   Go Up
Send this topic Print
Jump to: