Saddle Bag Guards

[greggh]

Needing the 2 bolts that attach the guards with the back tube that crosses behind/under the rear fender.
Having difficulty finding the schematics that shows the Bag Rails for a 1998 Tour.

Any help is certainly appreciated.
Thank you Gregg

[SCain]

I think the bolts are 6mm x 10mm long, they are a flanged head hex bolt. Valkyrie of Norway website has the installation instructions for the saddle bag guards.

[hubcapsc]

http://www.valkyrieriders.com/shoptalk/Manuals/BagRails1.pdf

http://www.valkyrieriders.com/shoptalk/Manuals/BagRails2.pdf

[Jess from VA]

And once you get those bolts, when installing with the little half clamps, they go on easier upside down than as shown in the instructions. 

[greggh]

And once you get those bolts, when installing with the little half clamps, they go on easier upside down than as shown in the instructions. 

It's all installed,
Just missing 2 bolts that hold the back of the guards together with the cross bar behind the gender

[gordonv]

If the link works, is 57 the one you're talking about?

https://www.procaliber.com/oem-parts?aribrand=HOM&arian=MOTORCYCLE#/Honda_Powersports/GL1500CFA_(99)_VALKYRIE_INTERSTATE%2c_USA%2c_VIN%23_1HFSC410-XA000001/SADDLEBAG/GL1500CF-99-A/14MBYXE1AMBY4F3900AC/y

[greggh]

Gordonv, the link did work.
The bolt needed is for the Bag Guards not the bag supports.
The furthest to back bottom rail connects to a bar that reaches behind the fender to the other guard rail.
There is a bolt 1 on each side connecting those sections of the Guards.
Thank you for the link tho.

[Jess from VA]

The (Honda or aftermarket-copy) bag rails are not going to be shown in the OE parts diagrams.

It's possible the bolt referred to is the same size as what he needs, but only possible.

The correct bolt is listed in the above PDF Honda bag rail 2-page instruction sheet (1st page), but it's not easy to see which is the exact one needed from the schematic.  Is it #8 or #10?

[SCain]

The (Honda or aftermarket-copy) bag rails are not going to be shown in the OE parts diagrams.

It's possible the bolt referred to is the same size as what he needs, but only possible.

The correct bolt is listed in the above PDF Honda bag rail 2-page instruction sheet (1st page), but it's not easy to see which is the exact one needed from the schematic.  Is it #8 or #10?

#10, 6mm x 12mm  long Flange Hex Bolt

[longrider]

I think the bolts he is talking about use an Allen key and thread into the solid rod at the end of each side of the center section rear.  They would be 6 mm by about 10 mm long

[greggh]

Thanks all for the sizes
Will get them both to save the trip back if needed.
Thank you all again!!