Stem Nut Tool WTB or borrow

GreenValk

Member

Posts: 49

NoVa

Stem Nut Tool WTB or borrow

« on: April 07, 2019, 05:38:42 PM »

I have a 97 Tourer with 56,000 miles. The handle bars are getting a little too easy to turn so I'm planning to work on the front end in a few weeks. Does anyone have the special stem nut too I could buy or borrow? I live in Northern Virginia and can pick up in person, or arrange for UPS pick up. Thanks, Steve


	Logged

hubcapsc

Member

Posts: 16776

upstate

South Carolina

Re: Stem Nut Tool WTB or borrow

« Reply #1 on: April 07, 2019, 05:45:06 PM »

Do you mean 07916-3710100? I have one of those you could borrow...

-Mike


	Logged

https://sites.google.com/a/g.clemson.edu/confederate-memorial-day-at-clemson/

98valk

Member

Posts: 13461

South Jersey

Re: Stem Nut Tool WTB or borrow

« Reply #2 on: April 07, 2019, 06:43:56 PM »

I'm doing the stem bearings at this time. I just made a tool today. An electric water heater element wrench, $7.27 Home Depot.

The round end outside diameter is the same. once material is removed and now you have your four tabs, the tabs need to be made thinner on the inside by removing some material. The hex, just use a socket for the torque wrench.

https://www.homedepot.com/p/Everbilt-5-in-Element-Wrench-15016/205680998


	Logged

1998 Std/Tourer, 2007 DR200SE, 1981 CB900C 10speed
1973 Duster 340 4-speed rare A/C, 2001 F250 4x4 7.3L, 6sp

"Our Constitution was made only for a Moral and Religious people. It is wholly inadequate to the goverment of any other."
John Adams 10/11/1798

GreenValk

Member

Posts: 49

NoVa

Re: Stem Nut Tool WTB or borrow

« Reply #3 on: April 09, 2019, 09:15:09 AM »

Thanks Mike that does look like the right tool. I will send you a note later to figure out the details.

Steve


	Logged

Pages: [1] Go Up

« previous next »