Break light

[Grey wolf oz]

Guys

Along with pulling the top box,

Any ideas on what break light from Honda models that fit the Valkyrie

I have fitted a standard small one as a short term

Again getting parts local that fit valkyrie specifically is tricky

[Bighead]

The BRAKE light is the same on the shadow Ace I believe.

[RonW]

You might need a Valk's rubber gasket ($16.25) since the Valk has a huge cavity molded in the rear fender for the tail light. The Shadow Ace 1100's gasket has just an outline shape that's designed to seal aroung the edge.

[Jess from VA]

The word is that a couple other Hondas (including the Shadow Ace) use the same tail light as the Valk, but the mount plate is supposedly not a quite right fit for the fender cutout.  I think they use the same lens. They have been made to fit and work, but I don't know any more detail.

If you will access Honda tail light parts fishes for Valk and others, you can compare part numbers.  

Valk (all years)
https://www.procaliber.com/oem-parts?aribrand=HOM&arian=MOTORCYCLE#/Honda_Powersports/GL1500CA_(99)_VALKYRIE%2c_USA%2c_VIN%23_1HFSC340-XA200001/TAILLIGHT/4a380688-44e5-4f7d-9a7d-1f19c6a1fb1b/2014a224-6918-4a83-bafd-e46ac3919148/y

Edited to correct 1100
SHADOW SABRE 1100 VT1100C2A (03)
https://www.procaliber.com/oem-parts?aribrand=HOM&arian=MOTORCYCLE#/Honda_Powersports/VT1100C2A_(03)_SHADOW_SABRE%2c_USA%2c_VIN%23_1HFSC430-3A300001_TO_1HFSC430-3A399999/TAILLIGHT/a49136fc-d558-42ac-a110-00d018748df7/c39ba1d8-713e-4bd7-ae78-95f0fc73b0b6/y

[RonW]

The word is that a couple other Hondas (including the Shadow Ace) use the same tail light as the Valk,

• but the mount plate is supposedly not a quite right fit for the fender cutout.

They have been made to fit and work, but I don't know any more detail.

the Valk tail light has threaded inserts (internal threads), while the other options have a plate with male screws. It's a do they line up question?

[Grey wolf oz]

Thank you every one for the replies

Luke

[MarkT]

BTW if you get the Radiantz multiple LED tailight for the Valk, it's directional alignment isn't right for the angle the fixture sits.  I was able to adjust it almost correctly, I think with a Dremel.  A bit disappointing considering the price over $100.  But it is very bright especially on braking and won't burn out.  Incidentally, I have found when LED's do fail it's always the connections.  Careful work with a soldering iron fixes them.

[Jess from VA]

My old Radiantz led array in taillight has about a half dozen leds out.

I don't care. 

I will say, an led array under an interstate trunk (shade) is brighter than in sunlight.

[Grey wolf oz]

Thanks guys !