Kuryakyn 4450 as rear footsteps

[Beer van Huet]

I bought a set of Kuryakyn 4450 ISO Wing Mini Boards at an auction and want to install them as rear footpegs.
The seller told me this was possible but I did not take a close look at that time.
Now that I want to install them I seem to need an adaptor.
Has anyone tried this before and can recommend an adaptor or any other way of installing them properly?


 

[Jims99]

If the angle is right, just add a spacer. Washers would work, or cut a piece of 1/2” copper pipe to fit in. If the angle is off you’ll need a different bracket.

[Beer van Huet]

Thanks Jims99

I can adjust the angle of the peg axis.
A spacer or filling will probably do, but will not stop the peg horizontally.
Besides, I am looking for something neat as well, not just functional

[Chrisj CMA]

I have them. The little springs that are supposed to hold them up when folded never worked good. I removed the sprigs because they tend to rust easily. Now they just stay in the riding position all the time

https://twitter.com/chrisj357/status/1516400995454136328?s=21

[Jess from VA]

Beer, it's my experience with Kuryakyn pegs and boards for Valkyrie, that the kind you got with a fixed mount are only for highway pegs (mounted to arms and clamps of some sort) and won't work for driver or passenger peg mounts.  And all their products for Valk driver and passenger peg mounts come "without ends" (no mounts), and then you have to buy the specific driver or passenger mount adapters for Valkyrie.

Now maybe they sell a very small/short arm that will mount those to the Valk rear peg position, say lifting them only 2 inches or so, but I don't think so.

You may be able to visit the Kuryakyn web site and ask for tech advice on mounting what you have to the Valk passenger position (or call them for tech advice).  

[Bagger John - #3785]

Add-On sold "Anti-Rotation Mounts" for the passenger pegs. They also sold peg adapters.

With a little mix and match creativity with those parts and Kuryakyn's, I got a number of floorboards to work with my Valkyries over the years. These were often swapped out as I re-styled the bikes from time to time.

[Beer van Huet]

I have ordered a set of adaptors on amazon.
I think these are the correct ones

 https://www.amazon.com/gp/product/B077B8VQYP/ref=ppx_od_dt_b_asin_image_s00?ie=UTF8&psc=1