Kuryakyn 4050 Pegs

[JimF2424]

Just installed Kuryakyn 4050.  They come with a 6" arm.  They have a 4.5 inch arm and a Mini Arm.  Purchased from J&P Cycles.

[GWS]

Nice! Those same pegs were on my bike when I bought it. Very solid & comfortable. I don't know how guys ride without highway pegs.

[Jess from VA]

Best highway pegs (and clamps) extant for Valk  (not a fan of Mick0pegs that move up and down).

I like the 4" arms. (short legs)

Be careful, as low as you have them, they may drag in a lean, and snap off in a tip over (I cannot see if folded up, they are interior or exterior to the guards (in a tip over).  They really should be inside the guards; laid over.  

Most move them up closer to the engine guards (and rotate the pegs for foot position).

[JimF2424]

Thanks for the advice, the 4.5 are not in stock, going to get them when in stock.  Ordered the mini's, they should arrive soon, will try them and post a pic.

[JimF2424]

Bought the Mini Arms, and they didn't fit, the bolt hole in the mini is to small.   I returned for a refund.
The instruction says reuse the existing bolt, but it doesn't fit the hole.  And was not about to drill it out.