Just to start things off, I have been a licensed Amateur Radio Operator since the early 1960’s. (Was WA4KPK, now KI4KZ). Not that active these days, but….
As part of this past, building and erecting antennas was a major part of the work needed to get on the air. Especially with low power (100 wats ) equipment.
So, today’s activity was to replace the small, all channel, TV antenna I had with a new Channel Master 2030 antenna. Its fairly large, something like fifteen feet long and maybe six feet wide. The hope was improved TV signal reception after the sun goes down.
I have scaffolding I purchased when building the house (three five foot sections give me up to 15 feet of reach.). Today, I used two sections to allow easy access to the mast where the antenna was going be mourned (replacing a much smaller antenna).
There were no real issues, just age related items of climbing the scaffolding and kneeling at the top when getting off the “ladder” portion of the scaffold.
Here is a picture of the end result.

I did do a brief antenna check after installation and verified I still get most of the stations I had gotten previously. Since this was done during daytime, I will have to wait until later tonight to check signal strength after it gets dark.
I don’t know if the stations lower there power input to their antennas at night or there is more interference at night. And with digital signals I think its either there or its not there.
And yes, it's not very high but there are reasons. Mainly I did not want a tower and I did not want to put it on the roof of the house. Metal roofs are very hard to climb (in my opinion). And an antenna on the roof means holes for screens and stuff. And the stations are relatively nearby (40 to 50 miles).
The major issue is with the upper band VHF and UHF. I will see what happens tonight.
Here is a picture of the older antenna (after removal).
