Valkyrie Riders Cruiser Club
June 15, 2025, 03:26:01 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 25
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > U-joint rebuild?
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: U-joint rebuild?  (Read 270 times)
Timbo1
Member
*****
Posts: 274

Tulsa, Ok.
« on: June 09, 2025, 10:22:20 AM »
Recently started noticing a vibration on deceleration.  Upon inspection I found the u-joint was bad.  Luckily I had previously purchased a used one from ebay so had a spare sitting on the shelf to get it going again.  To replace my backup I can buy new from about $190 - $237 or used from ebay varying prices.  Or since the yokes are fine rebuild what I have?

So my question is has anyone had success rebuilding the u-joint?  I seem to recall the topic being discussed but I've been unable to find any information on the process & part #'s.
Logged
Valker
Member
*****
Posts: 2995


Wahoo!!!!

Texas Panhandle
« Reply #1 on: June 09, 2025, 11:32:26 AM »
RonAyers.com has them for $176.66
Logged
I ride a motorcycle because nothing transports me as quickly from where I am to who I am.
98valk
Member
*****
Posts: 13439


South Jersey
« Reply #2 on: June 09, 2025, 12:31:27 PM »
Goldwing GL1500 uses the same u-joint. I've picked up a few low mileage ones over the yrs. they are still sitting on the shelf.
Logged
1998 Std/Tourer, 2007 DR200SE, 1981 CB900C  10speed
1973 Duster 340 4-speed rare A/C, 2001 F250 4x4 7.3L, 6sp

"Our Constitution was made only for a Moral and Religious people. It is wholly inadequate to the goverment of any other."
John Adams 10/11/1798
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS