Valkyrie Riders Cruiser Club
July 17, 2025, 09:02:35 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 17
Pages: [1]   Go Down
Send this topic Print
Author Topic: Replacement Headlights  (Read 1820 times)
DavRed
Member
*****
Posts: 345


Buckeye AZ

Phoenix AZ


« on: July 11, 2010, 11:55:35 AM »

Am I missing something?
I have replaced both headlights on my 2000 Interstate 2 times in the last six months. Angry And today again I found out both High beam lights are out again. I have been using the Silverstar Ultra 9003/HB2 H4, Lights.
I am starting to wonder if the washboard dirt road I have to travel from home for about a half mile, is causing this. I cant change that. So am looking for a beter light at this point.
I always ride with my high beem during the day. Rarely ride at night. Can't remember the last time we rode at night.

Replacement light sugestions welcome.
Logged
fudgie
Member
*****
Posts: 10613


Better to be judged by 12, then carried by 6.

Huntington Indiana


WWW
« Reply #1 on: July 11, 2010, 12:33:50 PM »

Was it just the hi's that went out then or both? My SS went out in 4 yrs.
Logged



Now you're in the world of the wolves...
And we welcome all you sheep...

VRCC-#7196
VRCCDS-#0175
DTR
PGR
DavRed
Member
*****
Posts: 345


Buckeye AZ

Phoenix AZ


« Reply #2 on: July 11, 2010, 01:27:34 PM »

Just the High's.
But I rarely run the Low's. Like I said. I run the high's, unless I am riding at night....
This is the second time in less than 6 months... same thing...

I am cutting the tabs off them except 1 that center's the bottom.
And not using any adapter if that makes a difference.
Just don’t want to spend another $60. For 3 months use….
« Last Edit: July 11, 2010, 01:31:13 PM by DavRed » Logged
Chrisj CMA
Member
*****
Posts: 14785


Crestview (Panhandle) Florida


« Reply #3 on: July 11, 2010, 01:46:28 PM »

If you dont ride at night then why get the most fragile bulbs on teh market....they are the brightest too, but short lived.  The XTRAVISON 9003/HB2 gives a good balance between brightness and durability
Logged
R J
Member
*****
Posts: 13380


DS-0009 ...... # 173

Des Moines, IA


« Reply #4 on: July 11, 2010, 06:20:45 PM »

Also, keep your oily fingers off of the glass on the bulb......

Mine are 5 years old........   They are starting to dim down some.

Probably change them out sometime this fall......
Logged

44 Harley ServiCar
 



 

DavRed
Member
*****
Posts: 345


Buckeye AZ

Phoenix AZ


« Reply #5 on: July 11, 2010, 06:50:00 PM »

Thanks Chris... I will try the xtravision ones. I am always carefull not to touch them when installing them. Just didn't realize they were so fragile. Probably just this dirt road....
Logged
X Ring
Member
*****
Posts: 3626


VRCC #27389, VRCCDS #204

The Landmass Between Mobile And New Orleans


« Reply #6 on: July 11, 2010, 07:34:38 PM »

Get the adapter rings.  It may prevent them from vibrating themselves to death. 

Marty
Logged

People are more passionately opposed to wearing fur than leather because it's safer to harass rich women than bikers.           
1FAST6
Member
*****
Posts: 164


Sanford, NC


« Reply #7 on: July 13, 2010, 08:34:23 AM »

I've been running PIAA Extreme White bulbs for almost 4 years now.  Almost always on High (with modulator).  More $$$ up-front, but maybe cheaper in the long run.  Extreme White Plus are vibration resistant for bikes, but I have the std.
Logged
Cattman
Member
*****
Posts: 383


Franklin, IN


WWW
« Reply #8 on: July 13, 2010, 08:51:58 AM »

I've been running NAPA H4 100/80 watt off road liights ($14) for years and one goes out every other year or so.
Logged


Baloo
Member
*****
Posts: 181


Rimouski, Canada


« Reply #9 on: July 13, 2010, 12:34:08 PM »

I've had the SilverStars for 2 years now with no problems. I too have to travel on a part of dirt road, but I don't use the highs very often, tough. When I installed the SS, I used the adapter rings. For the price, it might be a good idea to try them. Not sure, but they could help reducing the vibration on the bulb by holding them tighter. Could be an idea to switch to low beam (cooler light temperature) while traveling the dirt part of the road, then turn the highs on when hitting the pavement... just an idea.
Logged

Never ride any faster than your guardian angel can fly...
F6Dave
Member
*****
Posts: 2265



« Reply #10 on: July 13, 2010, 07:17:21 PM »

The Interstate headlights seem to burn out quickly.  I've replaced about 4 in 60K miles.  On my Tourer, I've replaced only 2 in 146K miles.  With the lower (45/45?) wattage I'm not sure why, but even at the ridiculous price Honda charges I don't lose any sleep over it -- I just keep a spare in the trunk.
Logged
Ricky-D
Member
*****
Posts: 5031


South Carolina midlands


« Reply #11 on: July 14, 2010, 07:29:04 AM »

I've good service from the stock Honda Interstate bulbs. First one burnt out and shortly thereafter the other burnt out.

I went ahead and got the rings looking to get cheaper bulb in the future.

The 45w/45w seem to be very good at night and I installed the modulator for daytime use.

It's important to not overburden the system wiring with too high a wattage bulb(s), there are many things that can happen from doing so and none of them is good!

***
Logged

2000_Valkyrie_Interstate
Pages: [1]   Go Up
Send this topic Print
Jump to: