Valkyrie Riders Cruiser Club
June 17, 2025, 04:09:34 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
VRCC Calendar Ad
Pages: [1]   Go Down
Send this topic Print
Author Topic: miss firing  (Read 2806 times)
art
Member
*****
Posts: 2737


Grants Pass,Or

Grants Pass,Or


« on: April 07, 2009, 03:18:54 PM »

I need help.My 2002 standard with 100000 mi. is running lousey at cruising speed .At about 45mph an holding it at a steady speed it starts to missfire an run ruff .this gets worse as the engine gets hotter up to running temp.I have checked the plugs an the are a br/grey..the vac. tubes look goodwith no cracks.I have run seafoam an no change.I'm thinking bad coil or bad plug wires.I have cut the piggies an instaled a 6% trigger wheel an get about 36 mpg two up with windshield at highway speeds.Help please an thanks.Art in Or.
Logged
YardBoy
Member
*****
Posts: 56


« Reply #1 on: April 07, 2009, 03:27:28 PM »

Thats where I'd start, might be a little easier once  you indentify the bank or specific cylinder/cylinders thats misfiring.
Logged
SCain
Member
*****
Posts: 619


Rio Rancho, NM


« Reply #2 on: April 07, 2009, 03:39:15 PM »

I would start by draining the fuel from the tank and carbs, get some fresh fuel preferably without ethanol and see how it runs before doing anything else.
I had an experience with a tank of bad fuel, ran great cold but when the engine got up to temp the fuel started to gel.
Just my .02
Logged

Steve
art
Member
*****
Posts: 2737


Grants Pass,Or

Grants Pass,Or


« Reply #3 on: April 07, 2009, 04:09:28 PM »

the fuel is not an issue .I have this problem for several months an a lot of different brands of gas with no change .I went on a 300mi. ride yesterday with two tanks of gas from two diff. areas with no change an got 36mpg. Art
Logged
Chrisj CMA
Member
*****
Posts: 14756


Crestview (Panhandle) Florida


« Reply #4 on: April 07, 2009, 04:15:03 PM »

You say the vacume lines look good.  How did you "look" at them?  Have they ever been changed?  Also I would be concerned that this could be petcock problems......those OEM valves seem to be worthless by 100,000 miles
Logged
Ricky-D
Member
*****
Posts: 5031


South Carolina midlands


« Reply #5 on: April 07, 2009, 05:29:30 PM »

If it runs good and you get 36 mpg, then I think you can eliminate any problem with the ignition system. Electrical components are either good or bad w/ very little in between.

I'd look for vacuum leaks, lines and 'o'-rings.

Are the carburetors synchronized properly?
Logged

2000_Valkyrie_Interstate
Pages: [1]   Go Up
Send this topic Print
Jump to: