Valkyrie Riders Cruiser Club
June 17, 2025, 03:38:37 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
VRCC Calendar Ad
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > IS Ignition Module on a Std Valk
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: IS Ignition Module on a Std Valk  (Read 2308 times)
Sasha47VSSS
Member
*****
Posts: 32


Malo les Bains, France
« on: April 10, 2009, 10:36:07 PM »
I've accquired the IS Ig.Module and intend to installit on my Std Valk. Is anything else required, except simple connecting? Any adjustment of the carbs?
Logged
Udo
Member
*****
Posts: 105


Germany, Krefeld
« Reply #1 on: April 11, 2009, 04:36:33 AM »
No, it´s plug and play. The rubber boot for the IS is a bit larger, cause the module is larger, but it does fit in the Standard / Tourer boot.
Logged
Bagger John - #3785
Member
*****
Posts: 1952
« Reply #2 on: April 11, 2009, 07:18:22 AM »
Now put a set of I/S carb springs in...and either shim the stock needles slightly or remove and replace with a set of DynoJet adjustable needles.

YMMV, but mine actually went up a few MPG...and the grin factor definitely did, especially when the motor is being revved under load from 1700-4000RPM. Much more responsive... cooldude
Logged
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS