Valkyrie Riders Cruiser Club
July 27, 2025, 01:09:40 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
VRCC Calendar Ad
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > Drilling Jets
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: Drilling Jets  (Read 1328 times)
hamman
Member
*****
Posts: 9
« on: March 21, 2011, 02:29:33 AM »
I have an extra set of stock slow and main jets.Anyone have any luck drilling out these jets one or two sizes rather than buy new.If I need to buy new can anyone recommend a vendor.TIA,Hamman
Logged
Patrick
Member
*****
Posts: 15433


VRCC 4474

Largo Florida
« Reply #1 on: March 21, 2011, 06:45:41 AM »
A vendor, Sudco..
As far as drilling, use to do it all the time years ago when parts were too expensive and hard to get for us kids.. Today I'd just buy a fist full and start screwing around..
If the bike as close to factory then the high jets[100] are fine, these monsters tend to run a bit rich on the high end anyway.. Some folks like changing the lows from 35 to 38,but, usually to just keep them from varnishing as quickly as they tend to do..
Logged
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS