Valkyrie Riders Cruiser Club
August 24, 2025, 09:33:24 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
VRCC Calendar Ad
Pages: [1]   Go Down
Send this topic Print
Author Topic: help me as to were to start looking.. wet issues ..  (Read 1783 times)
eric in md
Member
*****
Posts: 2495


ride hard now we all can rest when were gone !!!

in the mountains .......cumberland md


« on: May 28, 2011, 08:54:58 AM »

ok took 99  i/s to work yesterday rained like horses and cows on the bike, rain quit. i went to bike started right up was missing like somethings wet took like 5 miles for missing for it to dry up. all dry runs good again. so were do i start looking for the problem?  any ideas ? ok going back to work i will check with everybodys ideas later and thanks eric
Logged

Bone
Member
*****
Posts: 1596


« Reply #1 on: May 28, 2011, 09:25:45 AM »

Happened to me on a 1200 Goldwing. One spark plug was submerged Smiley
The boot on the plug wire end didn't seal close enough to the head surface.
Logged
shortleg
Member
*****
Posts: 1816


maryland


« Reply #2 on: May 28, 2011, 10:10:42 AM »

  ERic
   Check lowside plugs and maybe highside for water staying
in around  plugs. After engine heatsup water will evaporate.
          Shortleg[Dave]
Logged
Black Dog
Member
*****
Posts: 2606


VRCC # 7111

Merton Wisconsin 53029


« Reply #3 on: May 28, 2011, 12:40:28 PM »

Also check the vent tube that hangs under the bike (part of the Dragon Drool tube trio)...  Sometimes that sucks up water, and makes the beast run crappy.  I've read where others have shortened the tube, and had good luck.

Black Dog
Logged

Just when the highway straightened out for a mile
And I was thinkin' I'd just cruise for a while
A fork in the road brought a new episode
Don't you know...

Conform, go crazy, or ride a motorcycle...

Skinhead
Member
*****
Posts: 8731


J. A. B. O. A.

Troy, MI


« Reply #4 on: May 28, 2011, 03:11:36 PM »

I believe there is a drain hole in the spark pulg wells to allow any accumulated water to drain out.  Check and make sure none are plugged.  I suppose you could do this by pulling the spark plug boots and pouring water into each and making sure it drains out.
Logged


Troy, MI
bogator
Member
*****
Posts: 663


IN GOD WE TRUST------KK4KSN-------

Valley,Al


« Reply #5 on: May 29, 2011, 03:19:23 AM »

 I have not found a drain hole in the spark plug cup, but I did seal the rubber with silly-cone 2funny
Logged

giggles
Member
*****
Posts: 7


« Reply #6 on: May 29, 2011, 03:28:39 AM »

theres drain holes there you just need to look for them instead of taking the easy way out and making a mess with silicone  look under the head you'll see a little hole leading up into each spark plug cavaty
Logged
Cholla
Member
*****
Posts: 15


VRCC# 7578

Iowa Cornfield


« Reply #7 on: May 29, 2011, 06:25:38 AM »

Yep, here's the hole...  I was scratching my head about this hole back in 2003, back in the "old days"  Smiley



http://www.valkyrieforum.com/forum/tech_archive.cgi?read=432915#Responses

Logged

Like many travelers, I've seen more than I can remember and I can remember more than I've seen...
BradValk48237
Member
*****
Posts: 1717


Oak Park, MI


« Reply #8 on: May 29, 2011, 08:28:53 AM »

Had  1200 Wing for 15 years.... After almost stalling out  on the Highway in a heavy rain, I learned about the weep holes.... After that, I had a piece of wire in the saddle bag tool kit that would go through them to clean them out and became yearly maint.

B

Logged
Pages: [1]   Go Up
Send this topic Print
Jump to: