Valkyrie Riders Cruiser Club
September 17, 2025, 02:07:43 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Pages: [1]   Go Down
Print
Author Topic: New Tire Ruined  (Read 1062 times)
Hef
Member
*****
Posts: 708

Opdyke, IL 62872


« on: June 15, 2011, 07:21:17 AM »

My gal and I headed out this past weekend for a 1200+ mile ride which included parts of  Tennessee, Arkansas, Missouri and back to Illinois. We were on I-57 in Illinois headed south and gone about 90 miles when the front end began to weave and I knew we were in trouble. I pulled off as soon as possible. I had very little trouble in keeping the bike upright but it was a little weird. The back tire was flat and had a huge screw sticking in it. Both my tires had less than 1,500 miles on them. Removed the screw to see if I could plug it in order to get to a shop. No way. The hole was much too large. Called the towing service. they picked us up and took us to a shop in Cape Giradeau, MO. Had the tire replaced and back on the road almost 8 hours and $460 later. They charged me 3.2 hours labor for changing a rear tire???? ANyway, I was determined not to let it ruin the trip and the rest of the trip was without incident and we had a great time. Arkansas route 7 is a great run. Also had a good time in Branson, Mo. To quote my Granny "Always remember, it could have been worse"
Logged

Tundra
Member
*****
Posts: 3882


2014 Valkyrie 1800

Seminole, Florida


« Reply #1 on: June 15, 2011, 07:26:30 AM »

You kept it up, you finished your trip, you had a good time cooldude  (Yup...could have been worse)
Logged

If you can't be a good example: be a WARNING!!
Master Blaster
Member
*****
Posts: 1562


Deridder, Louisiana


« Reply #2 on: June 15, 2011, 09:18:24 AM »

Happened to me on a trip with Psycho and Valkyrie John to Niagara Falls.  On an I/S pulling a trailer.  Only difference was I ended up filling the hole with two mushrooms and one string plug, got it down to where it would hold for 200 miles so every gas stop would air up with my 12 volt pump.  Went 4000 miles like that and changed it out when I got back home.  Tire was severly cupped but made the trip without any delays and very little inconvinence.  We had a blast.
Logged

"Nothing screams bad craftsmanship like wrinkles in your duct tape."

Gun controll is not about guns, its about CONTROLL.
~ Timbrwolf
Member
*****
Posts: 1682


Northern Michigan VRCC # 8533


« Reply #3 on: June 15, 2011, 09:18:44 AM »

. ...was it an Avon ?


...Ive sworn off them...last 3 Avons Ive had picked up "something" in the road and went flat...all rear tires...all less then 1500 miles on em..


....last one was last summer on a Texas Road Trip on the Super Slab...right outside of Osceola Arkansas...Dealer in Memphis 60 miles away said all he had in stock was a Dunny E III. ..I said fine...no problems since...


...I did learn something though...NEVER order a pizza in...Osceloa Arkansas !  Evil
Logged

. . . ...I saw a werewolf at Trader Vics. . . ...his hair was perfect...
Big IV
Member
*****
Posts: 2845


Iron Station, NC 28080


« Reply #4 on: June 15, 2011, 09:29:36 AM »

You kept it up, you finished your trip, you had a good time cooldude  (Yup...could have been worse)

I'll admit that a Hondashop in the big city nearby charged me more to replace the rear tire on the Valk. They told me that it was because of bags and bag rail. What ev. Mid-trip repairs come fast or cheap but you can't get both.

I'm glad you were able to keep it upright and keep going.
Logged

"Ride Free Citizen!"
VRCCDS0176
Cliff
Member
*****
Posts: 930


Manchester, NH


« Reply #5 on: June 15, 2011, 10:56:08 AM »

Very happy for you that the result was ONLY a trashed tire.  Could have been far worse,, ride hard, long and safe!
Logged

VRCC # 29680
Hef
Member
*****
Posts: 708

Opdyke, IL 62872


« Reply #6 on: June 15, 2011, 11:12:10 AM »

Timberwolf, you asked if it was an Avon. Nope! It was Dunlop and replaced with a Dunlop. Note: I know what Smokin Joe says about Dunlops, but I have always had good service from them. Road hazard damage can happen no matter what brand you have.
Logged

RainMaker
Member
*****
Posts: 6626


VRCC#24130 - VRCCDS#0117 - IBA#48473

Arlington, TX


« Reply #7 on: June 15, 2011, 11:13:58 AM »

You kept it up, you finished your trip, you had a good time cooldude  (Yup...could have been worse)

Agreed.  I would have paid 10x that to avoid a crash and tumble, which would have really ruined your trip - good job keeping the bike upright.
Logged



2005 BMW R1200 GS
2000 Valkyrie Interstate
1998 Valkyrie Tourer
1981 GL1100I GoldWing
1972 CB500K1
Hoser
Member
*****
Posts: 5844


child of the sixties VRCC 17899

Auburn, Kansas


« Reply #8 on: June 15, 2011, 11:38:02 AM »

Lost a rear left bearing in Lacross WI last year. Honda shop did it, three hour delay, 264 dollars, done correctly.  That includes the bearing and a 30 mile trailer pick up.  I recommend them highly.   cooldude  hoser
« Last Edit: June 15, 2011, 11:41:04 AM by Hoser » Logged

I don't want a pickle, just wanna ride my motor sickle

[img width=300 height=233]http://i617.photobucket.com/albums/
Paxton
Member
*****
Posts: 2507


So Cal


« Reply #9 on: June 15, 2011, 05:36:16 PM »

I just read another thread that you might want to read. It addresses a preventive approach to tire failure.  Shocked

Thread title: "Ride-On Tire Sealant New in Tech Board."  cooldude
Logged

J. Paxton Gomez

1966 First year Bronco... 302 CI V8
1975 First year Chrysler Cordoba... 360 CI V8
1978 Honda 750F / Cafe Racer
2000 GL1500CY Fast-Black Standard Solo Rider

So Cal... 91205

"Four wheels move the body; two wheels move the soul."
Pages: [1]   Go Up
Print
Jump to: