Valkyrie Riders Cruiser Club
June 17, 2025, 03:12:11 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 25
Pages: [1]   Go Down
Send this topic Print
Author Topic: Vacuum line question  (Read 2194 times)
Rocketman
Member
*****
Posts: 2356

Seabrook, Texas


« on: April 28, 2009, 08:10:01 AM »

So, as I hinted in another post, I have a question about vacuum lines.
I was poking around at the intake runners, and found that runners 3 and 4 (middle runners) are connected at the vacuum port by a line that runs across the valley, and "t"s in the middle to head upwards into the unknown.  There was also a "t" that headed aft, but that line was capped off.  I've only had custody of this particular Valkyrie for ~6 months, so I'm not sure what has been done to it.  My previous Valkyrie had all these capped off (using a non-vacuum Pingle), but I'm not sure which is right, and where this vacuum line could lead.  No, there's not an AudioVox cruise on it.

Comments?

Mark
Logged

Rocketman
Member
*****
Posts: 2356

Seabrook, Texas


« Reply #1 on: April 28, 2009, 08:57:54 AM »

OK, I found the answer to most of my question at:
http://www.valkyrieriders.com/shoptalk/AirBox%20VentHose/venthose.htm
So the vacuum line runs to the pair valve, which my previous Valkyrie was lacking.
The remaining question would be why is there a separate branch that was capped off, but that's a lot less important.
Logged

RoboCop
Member
*****
Posts: 182


Rose City OREGON


« Reply #2 on: April 28, 2009, 08:59:30 AM »

from the manual, hope it helps.

Logged

Pages: [1]   Go Up
Send this topic Print
Jump to: