Valkyrie Riders Cruiser Club
August 17, 2025, 07:23:46 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > Final drive gear bearing removal
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: Final drive gear bearing removal  (Read 804 times)
Fritz The Cat
Member
*****
Posts: 1976


"The mountains are calling and I must go."
« on: July 14, 2012, 06:41:20 AM »
Anybody know how it's done?

It's item #27 here-

http://www.cheapcycleparts.com/model_years/838-honda-1998-valkyrie-gl1500c/assemblies/12352
Logged
lee
Member
*****
Posts: 263


Northeast Tennessee
« Reply #1 on: July 14, 2012, 06:54:29 AM »
Two flat screw drivers.  One on each side.  Just twist the handles its usually not that tight.
If you are replacing the ring gear and pinion that one is easy.  Number 1 bearing is the hard one.
« Last Edit: July 14, 2012, 07:01:35 AM by lee » Logged
Time is not what is taken but what remains.
C. Drewry
Fritz The Cat
Member
*****
Posts: 1976


"The mountains are calling and I must go."
« Reply #2 on: July 14, 2012, 07:11:29 AM »
Thank you sir. I didn't want to apply a whole lot of force if it required a special jig and a 20 ton press. Knowing that it did not allowed me to proceed. i had to use 2 crowbars rather than 2 screw drivers because twisting didn't budge it. But the crowbars popped it right off.  cooldude
Logged
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS