Valkyrie Riders Cruiser Club
July 06, 2025, 03:40:41 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Pages: [1]   Go Down
Send this topic Print
Author Topic: Remove Smog  (Read 1576 times)
LesPhelps
Member
*****
Posts: 2


« on: June 24, 2009, 07:08:27 PM »

I could use some help.  I did a partial smog removal to make room for an Audiovox cruise control and my bike is missing on more than one cylinder.  I haven't diagnosed whether the problem is vacum or electrical yet, but I figure if I'm going to open it up again, I'll do the entire smog removal.

The problem I ran into last time is that the pictures associated with the remove smog topic in the Shop Talk section of this website are missing.  My old eyes just aren't good enough to get adequate detail from the thumbnails on the instruction page.

Does anyone have the pictures that go with that mod or know of any other source for the smog removal instructions?

Thanks.
Logged
valk2128
Member
*****
Posts: 166


Suwanee, GA


« Reply #1 on: June 25, 2009, 02:05:29 AM »

Take a look at http://www.valkyrieriders.com/shoptalk/desmog.htm
Logged

Patrick
Member
*****
Posts: 15433


VRCC 4474

Largo Florida


« Reply #2 on: June 25, 2009, 03:44:11 AM »

desmog article was written by our very own Normand [Quexpress].. Speaking of Normand, where the heck has he been??
Logged
LesPhelps
Member
*****
Posts: 2


« Reply #3 on: June 25, 2009, 05:33:51 AM »

Thanks!  I was trying to work from the "Remove Smog" link several lines above the De Smog link.  Didn't occur to me that there would be more than one link on the same topic.

Excellent instructions on the De Smog link.
Logged
Pages: [1]   Go Up
Send this topic Print
Jump to: