Trying to find 7/8" to 1" handlebar adapters.

[John Schmidt]

I can find 1 1/8" adapters but that's a larger diameter than Valk handlebars. I used to see them all the time, now seem scarce as hen's teeth. Any suggestions where to look, haven't found any on Ebay, JP Cycles, etc.....looked at most of the suppliers I can think of.

[tank_post142]

just pick up a set of 7/8 risers?

[tank_post142]

like this ?
http://www.jensonusa.com/!Y!7QGdEOvTDY8kcobW7enA!/Problem-Solvers-Handlebar-Clamp-Shims-1?utm_source=FRGL&utm_medium=organic&gclid=CKDYm7SBt74CFQEdOgodPGYAgA

http://www.lowbrowcustoms.com/p300/buy/m-c-parts/bars-risers-amp-controls/risers/british-standard-handlebar-shims-reducers-run-7-8-inch-handlebars-with-1-inch-risers-or-p-clamps-/

also do a search in motorcycle parts/ebay for handlebar shims.

[Jess from VA]

I'm not sure I understand what you are looking for, but have you looked here?

http://www.flandersco.com/Products.html

[John Schmidt]

I already have the 7/8" riser as used on the GL1200, I have a Valk handlebar I want to use. Actually, they're not risers but an integral part of the top tree. I used to be able to find adapters that bolted into the 7/8" pocket, then the adapter was cut for 1" bars.

The look like this, only for 1" not 1 1/8".

http://www.ebay.com/itm/New-7-8-To-1-1-8-Handle-Bar-Adapter-Riser-Fat-Bar-Conversion-/360807017658?pt=Motors_ATV_Parts_Accessories&hash=item5401c62cba&vxp=mtr#ht_4253wt_1105

[tank_post142]

lemme check my parts boxes in the am

[jdp]

check out the dirt bike shops the motocross racers are going to 1 inch bars and they have the adaptors

[pitbull]

I found some in the UK, really pricey though

http://www.ebay.co.uk/itm/Handlebar-Risers-to-convert-to-standard-7-8th-to-Fat-Bars-Pro-taper-1-cr-ktm-yz-/221345723493?pt=UK_Motorcycle_Parts&hash=item33893bb465#shpCntId

[tank_post142]

John: what i found is a set of 1" valkyrie riser blocks. you could reshape the nub that fits into the original riser or just cut it off.