Valkyrie Riders Cruiser Club
August 16, 2025, 03:27:55 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Pages: [1]   Go Down
Send this topic Print
Author Topic: picked up a Jardine exhaust yesterday $100  (Read 1627 times)
blackcat
Member
*****
Posts: 138


Nicholas Vore VRCC # 30301

Mounds, Arkansas


« on: August 03, 2009, 01:17:04 PM »

i got a good deal on the exhaust, they do have some rust and blueing. i hope some blue remover can help, but the rust will have to be painted. and as of now i don't want the spend a lot having it powder-coated. Are there any header paints (rattle can) that are better than others?
Logged

______________________
03 Standard -Fast Black
00 Interstate - Red/Black
______________________
97 Tourstate - Yellow/Ivory
2010 Goldwing - Pearl Yellow
thelt
Member
*****
Posts: 50


RMC(SS) USN Ret. & Retired Police Capt.

Kingsland, GA


WWW
« Reply #1 on: August 11, 2009, 12:20:43 PM »

How bad is the rust? I bought a set of saddle bag rails and the underside had been scraped where the bike had been dropped.  I sprayed Ospho on it where the rust was starting.  Waited until the rust turned black (iron oxide) then clear coated from a rattle can.  Haven't had any rust problems since.  I don't know if the ospho will work on exhaust, but I'm pretty sure the clear coat will not, unless you can find a high temp clear coat.

There are other exhaust paints that might do the trick.
Logged

When asked what I did to make life worthwhile in my lifetime....I can respond with a great deal of pride and satisfaction, "I served a career in the United States Navy."

B
Member
*****
Posts: 576


Capital Area - Michigan


« Reply #2 on: August 11, 2009, 10:14:05 PM »

Rust I got rid of a couple of spots with 600-800 emery cloth. The previous owner decided to melt down gym shoes on the pipes; it was the only thing that would remove the age-old burnt crust.  It will dull the shine's brilliance, slightly; try it before you paint & see what you think.
Logged

"if I ride the morning winds to the farthest oceans, even there your hand will guide me." TLB-Ps.139:9-10
thelt
Member
*****
Posts: 50


RMC(SS) USN Ret. & Retired Police Capt.

Kingsland, GA


WWW
« Reply #3 on: August 12, 2009, 04:12:00 AM »

I don't want to hi-jack blacat's thread, but just a note on how to remove melted stuff like plastic shopping bags, shoe sole, etc... Use crumbled up Aluminium Foil. It won't dull or scratch the chrome and will take every bit of it off.
Logged

When asked what I did to make life worthwhile in my lifetime....I can respond with a great deal of pride and satisfaction, "I served a career in the United States Navy."

B
Member
*****
Posts: 576


Capital Area - Michigan


« Reply #4 on: August 13, 2009, 02:33:35 AM »

good to know - thanks
Logged

"if I ride the morning winds to the farthest oceans, even there your hand will guide me." TLB-Ps.139:9-10
Six Packer
Member
*****
Posts: 38


« Reply #5 on: August 13, 2009, 03:11:45 AM »

Acetone and a little elbow grease will do the job also.  Been there done that.
Logged
BarendR
Member
*****
Posts: 57


« Reply #6 on: August 02, 2012, 03:23:03 AM »

spray oven cleaner on cold pipes and let sit overnight, then wipe off.  Works like a charm  cooldude

And yes, I know this thread is 3 years old.

Barend
Logged
Pages: [1]   Go Up
Send this topic Print
Jump to: