Valkyrie Riders Cruiser Club
July 14, 2025, 07:23:44 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > Starter button service
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: Starter button service  (Read 556 times)
hoosier jaybird
Member
*****
Posts: 137

NE IN.
« on: March 13, 2015, 02:31:19 PM »
Doing preventive maintenance on my 99 IS I looked at the shop talk instructions for starter button disassembly and thought it looked easy enough. I took out the two screws that hold the housing assembly together and separated the two halves. The two throttle cables go up and over the throttle assembly and put enough tension on the lower half of the housing so that I can not get to the two small Phillips screws out to take out the switch. Apparently I am missing something to get enough slack to lower the switch housing. Any suggestions? Thanks.
Logged
Bighead
Member
*****
Posts: 8654


Madison Alabama
« Reply #1 on: March 13, 2015, 05:21:41 PM »
You can get them off (not easy) without taking them loose from the carb bank but you could loosen them on the other end and get more slack.
Logged
1997 Bumble Bee
1999 Interstate (sold)
2016 Wing
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS