Valkyrie Riders Cruiser Club
July 09, 2025, 06:02:57 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Pages: [1]   Go Down
Send this topic Print
Author Topic: Any problem with mixing these?  (Read 1377 times)
doubletee
Member
*****
Posts: 1165


VRCC # 22269

Fort Wayne, IN


« on: September 06, 2009, 04:54:03 AM »

The one on the right says "Synthetic." One on the left only says "High Performance." I'm thinking they're the same, just different packaging for marketing purposes.  BTW, are new brake pads normally a little noisier until they get seated? The new fronts seem to be dragging a lot more, going by the noise. However, the wheel spins freely, so I don't think they're hanging or binding:



« Last Edit: September 06, 2009, 05:06:58 AM by doubletee » Logged

  
sandy
Member
*****
Posts: 5388


Mesa, AZ.


« Reply #1 on: September 06, 2009, 07:55:12 AM »

Yes you can mix those two fluids. You cannot mix DOT5 silicone with DOT4.
Logged

sugerbear
Member
*****
Posts: 2419


wentzville mo


« Reply #2 on: September 06, 2009, 07:56:35 AM »

brake fluid is cheap, why bother. flush and fill with fresh.
when in doubt i throw it away and buy new.
Logged



doubletee
Member
*****
Posts: 1165


VRCC # 22269

Fort Wayne, IN


« Reply #3 on: September 06, 2009, 08:18:44 AM »

brake fluid is cheap, why bother. flush and fill with fresh.
when in doubt i throw it away and buy new.

That's essentially what I did, but just wanted to make sure any residual old stuff wouldn't cause a problem. Thanks for everyone's response.

BTW - the noisy fronts quieted right down after a little test ride.   cooldude
Logged

  
Pages: [1]   Go Up
Send this topic Print
Jump to: