Valkyrie Riders Cruiser Club
July 11, 2025, 09:59:50 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > Aftermarket radiator cap
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: Aftermarket radiator cap  (Read 902 times)
CoachDoc
Member
*****
Posts: 143


San Diego, CA
« on: September 22, 2015, 09:47:58 PM »
Seems to me I recall that there are aftermarket radiator caps that will fit a Valk. Mine is a '97 Standard. Does anybody have a NAPA or similar part number for a cap that will fit? Thanks as always.
Logged
CoachDoc
'97 Valkyrie Standard
'05 Goldwing
'74 CB550K
Kep
Member
*****
Posts: 480


My "Mid-life Crisis "

Indiana
« Reply #1 on: September 23, 2015, 06:02:29 AM »
I purchased a Mr.Gasket 2473S cap with a built in thermometer for my 97 standard...nice !!! Got mine from Amazon.com for $26.72
Logged
http://photo.vrccservices.com/albums/userpics/22897/2013-10-12_11_39_3728229_28640x48029.jpg
"If it's too LOUD...you're too OLD "
sandy
Member
*****
Posts: 5388


Mesa, AZ.
« Reply #2 on: September 23, 2015, 06:56:13 AM »
Kep: There have been several reports of leak failures with thermometer caps. How long have you had yours and have you had any issues with it?
Logged
http://i982.photobucket.com/albums/ae310/sandyal55/ManCave.jpg
Tfrank59
Member
*****
Posts: 1364


'98 Tourer

Western Washington


WWW
« Reply #3 on: September 23, 2015, 02:40:47 PM »
I bought that Mr gasket radiator cap with the thermometer built-in, and it worked good for about six months or so, and then the thermometer died. It didn't leak or anything, but I went back to the Honda one just because what's the point if thermometer is broken?
Logged
-Tom

Keep the rubber side down.  USMC '78-'84
'98 Valkyrie, ‘02 VTX 1800, '96 Royal Star, '06 Drifter, '09 Bonneville, '10 KTM 530, '04 XR 650, '76 Bultaco, '81 CR 450, '78 GS 750...
paulporter
Member
*****
Posts: 1
« Reply #4 on: October 04, 2015, 05:09:46 PM »
I had two of those caps.  Both leaked.  I threw them away and replaced with OEM.  No more coolant loss.
Logged
bentwrench
Member
*****
Posts: 760

Philadelphia,Pa.
« Reply #5 on: October 04, 2015, 05:19:01 PM »
I don't have any part#s but  caps from 90s toyota corollas fit almost every bike i've tried them on.I did this a couple of times for magnas,shadows and others that puked from a dried out cap seal.they are .9 bar like most bikes.get a stant if you can.
Logged
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS