Valkyrie Riders Cruiser Club
July 09, 2025, 07:23:15 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 17
Pages: [1]   Go Down
Send this topic Print
Author Topic: Front peg pin and cotter pin UGH  (Read 705 times)
Roidfingers
Member
*****
Posts: 729


Tuscaloosa, Alabama


« on: December 16, 2015, 12:12:19 PM »

What's the procedure for getting pin out of right front foot peg. Has brake assembly in the way.  Also any tricks to shifter side? Haven't looked there yet. Thanks
Logged
John Schmidt
Member
*****
Posts: 15223


a/k/a Stuffy. '99 I/S Valk Roadsmith Trike

De Pere, WI (Green Bay)


« Reply #1 on: December 16, 2015, 01:11:30 PM »

Hey Roid, I found it less trouble to simply remove the footpeg altogether, put it in a vice with a shop towel to protect it then disassemble it.
Logged

Roidfingers
Member
*****
Posts: 729


Tuscaloosa, Alabama


« Reply #2 on: December 16, 2015, 01:45:44 PM »

Looked at shop manual. Was only the two bolts holding the brake assembly thingy on. Got it all done. ISO look good. Unforunately the backs from Kury suck. Nothing to hold them upright. So took the one off and sending back. Any thoughts on rear pegs that will stay up?
Logged
Pages: [1]   Go Up
Send this topic Print
Jump to: