Valkyrie Riders Cruiser Club
March 15, 2026, 01:01:55 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Valkyrie Riders Cruiser Club > Chapter Boards > Florida Chapter > Have you tightened your 10mm exhaust acorn nuts lately?
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: Have you tightened your 10mm exhaust acorn nuts lately?  (Read 1644 times)
_Sheffjs_
Member
*****
Posts: 5613


Jerry & Sherry Sheffer

Sarasota FL
« on: March 03, 2018, 05:36:42 AM »
 Shocked
Logged
Chrisj CMA
Member
*****
Posts: 14931


Crestview (Panhandle) Florida
« Reply #1 on: March 03, 2018, 05:40:23 AM »
No but it's probably time. Thanks for the prompt. Them are sneaky little suckers
Logged
John Schmidt
Member
*****
Posts: 15383


a/k/a Stuffy. '99 I/S Valk Roadsmith Trike

De Pere, WI (Green Bay)
« Reply #2 on: March 03, 2018, 05:48:37 AM »
No....'cuz I replaced them with regular nuts 'n lock washers years ago. Haven't come loose since. Reason was simple, I found the acorns often didn't screw down tight enough before bottoming out...which prevents a tight fit. Probably due to the studs not all being screwed in all the way, something I wasn't going to try and correct after being in there for all that time.
Logged
Chrisj CMA
Member
*****
Posts: 14931


Crestview (Panhandle) Florida
« Reply #3 on: March 04, 2018, 12:06:05 PM »
Done  cooldude  Both bikes.  Needed it.  Also did all the intake runner clamp screws.  Dont forget them.  Doubt you can put any locking mechanism on them to keep from having to check em  Wink
Logged
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS