Valkyrie Riders Cruiser Club
March 16, 2026, 04:46:28 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
VRCC Calendar Ad
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > Need some advice concerning the headset bearings.
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: Need some advice concerning the headset bearings.  (Read 2307 times)
FryeVRCCDS0067
Member
*****
Posts: 4353


Brazil, IN
« on: February 26, 2010, 04:05:57 PM »
I’m just getting started changing my headset bearings and would like some advice from those who have done it before. Because I’ve added two relays and the wiring for three additional lights into my headlight housing in addition to my voltage meter being wired-in there I would rather avoid pulling all the wires out of the headlight bell and removing it. In particular since I didn’t use quick disconnects any more than I had too.

Question is, can I just remove the headlight mounting bolts from the lower triple clamp and let the housing hang while I remove the forks, upper triple clamp and steering stem?

Thanks,
Frye
Logged
"Extremism in the defense of liberty is no vice.
And... moderation in the pursuit of justice is no virtue.''
-- Barry Goldwater, Acceptance Speech at the Republican Convention; 1964
quexpress
Member
*****
Posts: 519


Montreal, Québec, Canada


WWW
« Reply #1 on: February 26, 2010, 04:28:27 PM »
Yes, just use bungee cords or whatever to help support the headlight (and not hurt the electrical wiring).  Smiley
Logged
I still have a full deck.
I just shuffle slower ...
Daniel Meyer
Member
*****
Posts: 5493


Author. Adventurer. Electrician.

The State of confusion.


WWW
« Reply #2 on: February 26, 2010, 04:32:31 PM »
That's what I did.
Logged
CUAgain,
Daniel Meyer
Hoser
Member
*****
Posts: 5844


child of the sixties VRCC 17899

Auburn, Kansas
« Reply #3 on: February 26, 2010, 05:29:50 PM »
My headset works very well, nice separation, no static, a lot better than the the speakers, does that mean My bearings are OK?    2funny  uglystupid2 hoser
Logged
I don't want a pickle, just wanna ride my motor sickle

[img width=300 height=233]http://i617.photobucket.com/albums/
FryeVRCCDS0067
Member
*****
Posts: 4353


Brazil, IN
« Reply #4 on: February 26, 2010, 05:37:14 PM »
Sweet! Thanks guys.  The wood burner is going in the garage, the Valk is waitin' and the snow is startin' to melt outside so I'm heading back out.
Thanks again.
Frye
Logged
"Extremism in the defense of liberty is no vice.
And... moderation in the pursuit of justice is no virtue.''
-- Barry Goldwater, Acceptance Speech at the Republican Convention; 1964
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS