Wanted - unwanted, Damaged or poor condition IS pods.

[Skinhead]

I'm looking for a cheaper the better set of IS pods for a mad science project.  I'm really interested in the pieces where you would cut out to mount fog lights.  I bought a set of LED aux headlights that I'd like to mount in the pods don't want to F-up a good set of pods on something that may require going back to the drawing board.  Black preferred, but any color will do.  Thanks.

Skinhead

[Steel cowboy]

Check Pinwall salvage

[bill-jr]

I have somebut already have holes cut in them 

[Skinhead]

I have somebut already have holes cut in them 

That's what I'm going to do with them anyway.  Could you send me a pic of them and how much you want for them?

[NJF6Cowboy]

If you are looking to install your new lights in uncut pods. The inside of pod has a mark out line showing where to cut for the fog lights. I drilled pilot holes 1/8" diameter around perimeter of mark out and then finish cut with a disc wheel and sanding bit on my Dremel.
If your lights are smaller than the mark out, measure and pre drill accordingly. I hope this helps you.

Stan

[bill-jr]

Im outta town for anither week then ill send you pics joe they are busted up by the screw holes on top a bit and the holes are cut look like a hack job really but id send em to you for cost of shipping if youd like ....

[Skinhead]

Im outta town for anither week then ill send you pics joe they are busted up by the screw holes on top a bit and the holes are cut look like a hack job really but id send em to you for cost of shipping if youd like ....

Sounds good Bill, it'll give me something to mock things up before doing surgery on my "good parts".  Hit me up when your back in town.