Valkyrie Riders Cruiser Club
June 15, 2025, 05:14:58 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 25
Pages: [1]   Go Down
Send this topic Print
Author Topic: Looking for someone to work on my Valkyrie  (Read 3552 times)
etiwandablues
Member
*****
Posts: 33


Kennewick, WA


« on: December 05, 2019, 02:44:27 PM »

 I'm looking for someone in the PNW, hopefully close to TriCites WA, to work on my valk. It's an 03 standard ~20k mile. I don't have the time or inclination to ride anymore so I'd just like to get it running good and find a new home for it. After sitting hydrolocked for a few yrs, i pulled the engine this past spring and  repaired the hydrolock damage (idler gear), thoroughly cleaned the carbs and replaced all the rubber bits with the full redline kit. Replaced all the jets as well. Somewhat to my surprise it started right up and ran great, actually smoother than ever.

Now after sitting again for 5 months, it will only start and run with the choke full on. It's a nice bike .. Woody's fairing, MarkT pipes, qd bags, belly tank, ultimate seats, new avons, etc and super clean & shinny. I need to move on so if anybody has a recommendation for a good shop or mechanic i'd appreciate it. Have trailer, will travel. Thanks
Logged
etiwandablues
Member
*****
Posts: 33


Kennewick, WA


« Reply #1 on: December 07, 2019, 09:34:30 AM »

Will also consider selling cheap
Logged
etiwandablues
Member
*****
Posts: 33


Kennewick, WA


« Reply #2 on: December 10, 2019, 07:51:52 AM »

very cheap
Logged
Rollerman Dan
Member
*****
Posts: 29


Mt Vernon WA


« Reply #3 on: March 01, 2020, 10:40:59 AM »

You sell this bike yet
Logged
Pages: [1]   Go Up
Send this topic Print
Jump to: