Valkyrie Riders Cruiser Club
July 13, 2025, 09:37:04 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 17
Valkyrie Riders Cruiser Club > General > General Board > Non Valk Carb Issue
Pages: [1]   Go Down
« previous next »
Print
Author Topic: Non Valk Carb Issue  (Read 379 times)
pais
Member
*****
Posts: 723


One more turn should do it!

Kent, Ohio
« on: March 22, 2020, 06:32:21 AM »
https://www.toro.com/en/parts/partdetails?id=3047

After putting new belt on snow thrower last night. I decided to drain carb of gas. While doing that, I wiped down carb bowl and around the ring of the carb. Just as I did this, a spring/clip fell out  crazy2. I have no clue where it fell from. I found it on parts fiche, but still do not know where it goes? It is #'s 30 & 31. Anybody read the fiche better than me? Thanx!
Logged
Better to have it and not need it, than to need it and not have it!
signart
Member
*****
Posts: 2095


Crossville, Tennessee
« Reply #1 on: March 22, 2020, 07:58:07 AM »
That has to be what raises/lowers the needle, so that coil spring & pin goes in between the dog ears and then the clip as oriented in diagram. The groove in the needle would catch on the curl of the clip.
Logged
Pages: [1]   Go Up
Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS