Signal Boss Issue on 99 Interstate

[moreira72]

I recently installed the Jersey Signal Boss on my 99 I/S. Everything works as it should, Auto-cancel, Hazards, and Parade mode work fine.

My issue is when I release the brakes (front or back) in any gear the hazards flash twice. And if I have the turn signals on when I apply the brakes, they cancel and hazards flash twice when I release the brakes. only does it in gear. in neutral the hazards don't flash when brakes are applied and release.

Let's say I'm approaching on a turn, turn on my right or left turn signal, and brake to slow down, the turn signal gets canceled and when I release the brake the hazards flash twice.
I don't have any brake modulators or LED bulbs that might be causing this.
Just wondering if anybody else has this issue?
I have the auto-cancel set to about 10 seconds

[Chrisj CMA]

If Jersey doesn’t respond here I would send him a pm. He’s great at diagnosing his stuff 

[Jersey]

I recently installed the Jersey Signal Boss on my 99 I/S. Everything works as it should, Auto-cancel, Hazards, and Parade mode work fine.

My issue is when I release the brakes (front or back) in any gear the hazards flash twice. And if I have the turn signals on when I apply the brakes, they cancel and hazards flash twice when I release the brakes. only does it in gear. in neutral the hazards don't flash when brakes are applied and release.

Let's say I'm approaching on a turn, turn on my right or left turn signal, and brake to slow down, the turn signal gets canceled and when I release the brake the hazards flash twice.
I don't have any brake modulators or LED bulbs that might be causing this.
Just wondering if anybody else has this issue?
I have the auto-cancel set to about 10 seconds

Moreira72,

I sent you an email.  Rather not do troubleshooting on the forum.

Thanks,
Steve

[moreira72]

I recently installed the Jersey Signal Boss on my 99 I/S. Everything works as it should, Auto-cancel, Hazards, and Parade mode work fine.

My issue is when I release the brakes (front or back) in any gear the hazards flash twice. And if I have the turn signals on when I apply the brakes, they cancel and hazards flash twice when I release the brakes. only does it in gear. in neutral the hazards don't flash when brakes are applied and release.

Let's say I'm approaching on a turn, turn on my right or left turn signal, and brake to slow down, the turn signal gets canceled and when I release the brake the hazards flash twice.
I don't have any brake modulators or LED bulbs that might be causing this.
Just wondering if anybody else has this issue?
I have the auto-cancel set to about 10 seconds

Moreira72,

I sent you an email.  Rather not do troubleshooting on the forum.

Thanks,
Steve

The Question was not addressed directly to you Steve. I was trying to get feedback from possible users of the signal boss that may be having or had the same issue as I'm having. There may be a member that had the issue and corrected on their own. After all, this is a tech board.

Thanks,
moreira72