Valkyrie Riders Cruiser Club
June 15, 2025, 12:01:09 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 17
Valkyrie Riders Cruiser Club > Chapter Boards > SoCal Chapter > Remove Baffles on cobra 6 into 6?
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: Remove Baffles on cobra 6 into 6?  (Read 5741 times)
Guitarmoto
Member
*****
Posts: 13
« on: October 20, 2021, 01:13:42 PM »
So I noticed that the baffles on my cobra pipes that the baffles are right in the rear and secured by a single screw. For craps and giggles, I backed out the screws on two baffles to see if they just slide right out. They did lol. So I fired up the bike to see the difference. Little difference, but again its just 2 baffles out of the 6, one on each side. I have no intention of jacking up my bike by screwing around with things.

My question, If I remove the baffles will I need to re-jet my bike you think? What are the implications of removing the baffles?
Logged
Guitarmoto
Member
*****
Posts: 13
« Reply #1 on: October 20, 2021, 02:52:19 PM »
Ok, ya that makes sense. I will try with all removed. Worst case is it chokes out or something and I need to slide them back in, right?
Logged
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS