Who makes the chrome engine covers?

[John Schmidt]

This is the set that covers both sides of the motor, looking to dress up the Valk I'm going to be putting on the market in the near future. Also the chrome swingarm pivot covers that go below the side covers, not the swingarm cover itself. I used to have a set but been so long ago I don't recall where I got them.

[Jess from VA]

Kuryakyn. #7710

https://www.accessoryinternational.com/product/kuryakyn-transmission-cover-set-valkyrie.html?gad_source=1&gclid=EAIaIQobChMI4uaC5vzlhQMVXEdHAR2IygCcEAQYASABEgLB3vD_BwE

https://www.westendmotorsports.com/honda/valkyrie/chrome-accessories/

https://www.nicecycle.com/Honda-Valkyrie-Chrome-Transmission-Cover-Set-p/trkuryackyn-132.htm

https://www.saber-cycle.com/transmission-side-covers-valkyrie.html

Show Chrome swingarm pivot covers (milled)   (may no longer be available) 

https://fortnine.ca/en/show-chrome-big-bike-parts-swing-arm-pivot-cover-valkyrie-1-325

https://www.accessoryinternational.com/valkyrieswingarmpivotcover.htm

https://www.valkyrieparts.de/Chrome-Swingarm-Pivot-Covers

[John Schmidt]

Jess, you have more patience than I.    Thanks!

[Mooskee]

John, we have engine hanger covers. They are laser cut from mirrored stainless steel. They cover around the key on one side and the fuel control knob on the other. We also make a custom set that is for those who have removed the petcock knob and installed a Pingel or other manual petcock You can see and/or purchase them on our web site. www.valkyriecarbsandcustom.com

Dave

[John Schmidt]

Thanks Dave, I have an old set not used for many years but haven't decided if I want to install them.

[h13man]

John, we have engine hanger covers. They are laser cut from mirrored stainless steel. They cover around the key on one side and the fuel control knob on the other. We also make a custom set that is for those who have removed the petcock knob and installed a Pingel or other manual petcock You can see and/or purchase them on our web site. www.valkyriecarbsandcustom.com

Dave

Or get some 1/16" aluminum and trace the bracket & holes. I painted mine black to finish the look w/o the ugly arse holes etc. Easy cutting on table top band saw and the slight bend was done in my bench vise.