VALKYRIE U JOINT UPDATE
Robert:
If you want to rebuild the joint heres how to do it and thanks to Jay for providing the number
http://www.rockforddriveline.com/replacem.htm
http://www.rockforddriveline.com/ujointinside.htm
http://www.rockforddriveline.com/Staked_Instructions.htm
Hoser:
Quote from: Jay on October 12, 2010, 02:31:14 PM
Correction: it is a Spicer 430-9A
Thanks, I'll be getting one tomorrow. Hoser
Valk1520:
Sorry but just want to be sure, the Spicer 430-9A fits right from the box with no mods? I'll order one as soon as you can confirm because I'm afraid my u-joint might be going bad. Thanks!!
NITRO:
Is this the same one? http://theujointstore.com/44310.html
Sodbuster:
Quote from: Valk1520 on October 12, 2010, 06:43:21 PM
Sorry but just want to be sure, the Spicer 430-9A fits right from the box with no mods? I'll order one as soon as you can confirm because I'm afraid my u-joint might be going bad. Thanks!!
The only concern I would have is if the inside "B" dimension is a machined surface or not. Also if the dimension on the u-joint is a little large how do you make up the difference to eliminate any "slop" ??
Navigation
[0] Message Index
[#] Next page
[*] Previous page