Question regarding Jardine exhaust

[Grandpa Bigbuck]

My wifes Valkyrie trike has Jardine exhaust with no baffles.  Finally found some baffles but have no idea on how to mount them.  If anyone has any input it would be appreciated. Thanks

[R J]

Most baffles slide up the exhaust pipe and have a bolt,(cap screw) that holds them in place.......

[aslondon]

If they are the "Rumblers" which end about under the rear axle then look for I think 2 or maybe 3 small holes a couple of inches in from the end where the baffles were riveted in place.  I have a set on my bike so if you have any questions let me know

Al
VRCC 4321

[Grandpa Bigbuck]

If they are the "Rumblers" which end about under the rear axle then look for I think 2 or maybe 3 small holes a couple of inches in from the end where the baffles were riveted in place.  I have a set on my bike so if you have any questions let me know

Al
VRCC 4321

Thanks Al.  I'm assuming that the cone shaped end goes in first and the square cut end is in the back, and I need to drill through the flange on the square cut end and use pop rivets to attach to the exhaust.  Is this correct?

Dave