Valkyrie Riders Cruiser Club
July 22, 2025, 09:33:46 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 17
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > Rostra Cruise install
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: Rostra Cruise install  (Read 1205 times)
RLD
Member
*****
Posts: 318


'99 I/S Red/Black

Eden Prairie, MN
« on: November 27, 2010, 11:39:26 AM »
Question. I'm mounting my servo, I have all the mounts ready, wiring harness shortened, cable routed; when I notice in the installation manual to mount the servo at least 10" from the coils. I was planning to mount it under the fuel petcock, which is only a couple inches from a coil. Has anyone else mounted theirs in this location? Does it work? Any thoughts at all? I'd hate to start over now, but it has to work. I'm guessing the concern is over electrical "noise" interfering with the servo, but it's only a guess.
Logged
Dress for the slide, not the ride. ATGATT
VRCC #2505
X Ring
Member
*****
Posts: 3626


VRCC #27389, VRCCDS #204

The Landmass Between Mobile And New Orleans
« Reply #1 on: November 29, 2010, 09:08:24 PM »
Iirc, Punisher mounted his inside the fairing on his I/S.

Marty
Logged
People are more passionately opposed to wearing fur than leather because it's safer to harass rich women than bikers.           
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS