Valkyrie Riders Cruiser Club
June 17, 2025, 09:27:44 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 25
Pages: [1]   Go Down
Send this topic Print
Author Topic: What Size NUTS?????  (Read 2558 times)
rmrc51
Member
*****
Posts: 1087


Freyja. Queen of the Valkyries

Palmyra, Virginia


« on: April 02, 2009, 10:07:58 AM »

Please let me clarify!!!!!  Roll Eyes

I'm installing an Interstate Tank on my 97 Standard. I already ordered and received the fuel sending unit from HDL but it didn't include the 4 nuts and I assume washers to secure the sending unit to the tank. Rather than wait another 2 weeks to order them, does any one know what size these nuts are so I can pick them up from a hardware store?????  coolsmiley
Logged

VRCC # 30041
Madmike
Member
*****
Posts: 837


Campbell River BC, Canada


« Reply #1 on: April 02, 2009, 11:12:41 AM »

Parts fiche says 6mm - no pitch given, check #29 on this fiche.  Common thread pitch is 1mm.

http://www.hdlparts.com/fiche_section_detail.asp?section=148545&category=Motorcycles&make=Honda&year=1999&fveh=3473
Logged
rmrc51
Member
*****
Posts: 1087


Freyja. Queen of the Valkyries

Palmyra, Virginia


« Reply #2 on: April 02, 2009, 11:39:18 AM »

Parts fiche says 6mm - no pitch given, check #29 on this fiche.  Common thread pitch is 1mm.

http://www.hdlparts.com/fiche_section_detail.asp?section=148545&category=Motorcycles&make=Honda&year=1999&fveh=3473


Thanks. I had also just found the same link. I'll try for the 1mm thread pitch as you suggested.  cooldude
Logged

VRCC # 30041
Pages: [1]   Go Up
Send this topic Print
Jump to: