Valkyrie Riders Cruiser Club
August 21, 2025, 10:43:41 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > cruise question
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: cruise question  (Read 836 times)
plcae
Member
*****
Posts: 5
« on: October 30, 2011, 06:13:05 PM »
my audiovox cruise blows my fuse? anyplace I should look first? was working fine since installed only not as sensitive as before.  thanks for any help
Logged
John Schmidt
Member
*****
Posts: 15260


a/k/a Stuffy. '99 I/S Valk Roadsmith Trike

De Pere, WI (Green Bay)
« Reply #1 on: October 30, 2011, 08:24:27 PM »
Check to see how sharp a bend you have in the cable running from the servo to the carb linkage. You don't want it less than about four inches across otherwise it will bind when activated. The other thing might be the connector that hooks the controller on the handlebar to the servo. If you have a Tourer or Std., that connector is open to the elements. I cut it off and soldered the wires together and insulated them real good. Then made my connections under the seat where it's all covered.

Just a couple ideas.
Logged
Mr Bojangles
Member
*****
Posts: 62

Bonham Texas
« Reply #2 on: October 31, 2011, 06:14:13 AM »
Does it blow at random times or does it blow (the fuse) as soon as you replace it?
                                                  BoJangles
Logged
Still on the right side of dirt, it is a good day!
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS