Valkyrie Riders Cruiser Club
August 19, 2025, 11:20:05 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 17
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > Intake o-ring install
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: Intake o-ring install  (Read 931 times)
vw70blue
Member
*****
Posts: 22

Tampa, FL
« on: April 18, 2012, 06:25:15 AM »
Just got my o-rings from Redeye. Thanks to jrhorton for the tip. I was thinking about replacing the one that was leaking. Since it was so easy to replace, I decided to replace the others. Good thing I did. All o-rings were leaking. I notice that brown stuff on the outside of the o-rings and all were soaked w/ gas. I appreciate everybodys input. This forum is the best. Thanks again. Roll Eyes
Logged
9Ball
Member
*****
Posts: 2183


South Jersey
« Reply #1 on: April 18, 2012, 06:53:37 AM »
now you're a Valk mechanic....your next project should be to inspect all the vacuum tubing (PAIR valve and petcock) and intake vacuum plugs and replace them as they are probably old and will eventually cause you problems.  Redeye.tech sells these too.

Good luck....
Logged
VRCC #6897, Joined May, 2000

1999 Standard
2007 Rocket 3
2005 VTX 1300S
vw70blue
Member
*****
Posts: 22

Tampa, FL
« Reply #2 on: April 18, 2012, 05:17:40 PM »
It's all done. Thanks
Logged
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS