Valkyrie Riders Cruiser Club
November 24, 2025, 10:22:44 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
VRCC Calendar Ad
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > desmog
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: desmog  (Read 992 times)
Dozer
Member
*****
Posts: 211


Humble, Tx
« on: May 31, 2012, 04:36:51 PM »
after complete desmog there are bolt holes left where the bolts attached the PAIR valves. Does anyone bother plugging those holes? The original bolts are too long. Is it worth buying shorter bolts to fill them? Any issues that I may not be aware of if left open?
Logged
98valk
Member
*****
Posts: 13661


South Jersey
« Reply #1 on: May 31, 2012, 04:40:05 PM »
aluminum does corrode where moisture, dirt and etc., can collect, put some bolts in IMHO.
Logged
1998 Std/Tourer, 2007 DR200SE, 1981 CB900C  10speed
1973 Duster 340 4-speed rare A/C, 2001 F250 4x4 7.3L, 6sp

"Our Constitution was made only for a Moral and Religious people. It is wholly inadequate to the goverment of any other."
John Adams 10/11/1798
Thunderbolt
Member
*****
Posts: 3731


Worthington Springs FL.
« Reply #2 on: May 31, 2012, 04:43:09 PM »
I always cut them in half,round the ends a little and put them back in.
Logged
GJS
Member
*****
Posts: 424


Today is the tomorrow you worried about yesterday.

Vancouver Island, BC, Canada
« Reply #3 on: May 31, 2012, 04:45:44 PM »
Or

Blow out the holes and fill with Silicone sealant. Silicone can handle the heat and be picked out if needed.

Logged
The tragedy of life is not that it ends so soon, but that we wait so long to begin it.
- W. M. Lewis
Dozer
Member
*****
Posts: 211


Humble, Tx
« Reply #4 on: May 31, 2012, 06:15:23 PM »
Okay...the consensus is to plug them...will do. I cleaned that whole "vally" area and repainted it with silver brake caliper paint from Advance Auto. Its an almost exact color match and its good to 700 degrees. If the block gets that hot Id be surprised! I polished the chrome water tubes with liquid Bar Keepers Friend. Great stuff...took off all of the rust specks and left it shiney..sure looks nice and clean and no clutter. Red eyes desmog kit sure is nice...professional looking too. I almost hate to put the carb bank back on.....lol...no I dont!

Thanks for the speedy input guys. Great help.
Logged
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS