Valkyrie Riders Cruiser Club
August 16, 2025, 11:28:51 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Pages: [1]   Go Down
Send this topic Print
Author Topic: Side stand switch install  (Read 819 times)
flatsixrider
Member
*****
Posts: 273


2000 Standard

Greenville, SC


WWW
« on: July 20, 2012, 01:33:36 PM »

Mine has been disconnected for YEARS and I would like to reconnect.  Does anyone have photos of the installed switch?  I tried what I thought was right and no go.  TIA!
Logged



Sometimes the appropriate response to reality is to go insane.
sandy
Member
*****
Posts: 5401


Mesa, AZ.


« Reply #1 on: July 20, 2012, 03:15:06 PM »

I hope this helps. I remember a pin going into a small hole to prevent movement of the switch.


Logged

flatsixrider
Member
*****
Posts: 273


2000 Standard

Greenville, SC


WWW
« Reply #2 on: July 20, 2012, 04:55:02 PM »

I hope this helps. I remember a pin going into a small hole to prevent movement of the switch.


That might help, thanks!
Logged



Sometimes the appropriate response to reality is to go insane.
Bone
Member
*****
Posts: 1596


« Reply #3 on: July 20, 2012, 05:44:51 PM »

Here is another picture;

Logged
flatsixrider
Member
*****
Posts: 273


2000 Standard

Greenville, SC


WWW
« Reply #4 on: July 20, 2012, 07:16:09 PM »

That almost gets me there!  Just cannot see the little tab from the switch, though I think a bit of trial and error will work.  Thank you.
Logged



Sometimes the appropriate response to reality is to go insane.
Pages: [1]   Go Up
Send this topic Print
Jump to: