clutch tool help!!!

[shortleg]

What do you need to build a tool to take the clutch
basket apart.
   BigBF is here and needs one to replace and repair one.
           Shortleg[Dave]

[WamegoRob]

36mm or 1 13/16 socket, sawn in half with a 2" extension welded in:

[tank_post142]

if you are talking about compressing the spring to pull the snap ring: i used a piece of thick walled pvc. just cut a 1-1/2 section out so you can reach in with the snap ring pliers. i just compressed it by setting it between my floor jack and the bumper on my van.

[BigBF]

No worry... It's done remove snap ring off, we use C-clamps to compress and removed. But it did not do well. I'll have my wife send me the tool for it or I'll make one here I think I better make one and cheaper than have her mail it.  So I can install back together without headaches.

[pocobubba]

Seems like a big valve spring compressor would do the job .

[BigBF]

FYI: 36mm incorrect. Correct is 46mm.