Pulled apart the caliper and aligned the pin in the rubber boot after
cleaning everything (again) with brake cleaner bled both sides and topped off with fresh synthetic dot3/4 fluid
I did put a very thin bit of synthetic mobil 1 grease on the pins and then wiped both clean with my fingers
started the Valkyrie and rode up and down the block testing the brakes, the snow last night was all melted away and no salt was put down by the town
all seems as it should be
Thank you to everyone
Maybe when I get to Kentucky, one of our brake experts can tell me if everything is properly done and how the pads are wearing
Felt REALLY good to be in the breeze even if it was freezing out
