Valkyrie Riders Cruiser Club
September 12, 2025, 05:13:59 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 17
Pages: [1]   Go Down
Send this topic Print
Author Topic: radiantz brake module question  (Read 917 times)
al v
Member
*****
Posts: 227


Clinton Township, MI


« on: August 06, 2013, 07:05:56 PM »

Anyone using the strobe flash mode of the radiantz brake module or similar brake module? (Instead of just the standard flash mode)

Strobe mode when combined with a radiantz led taillight seems like way to much.

If anyone has tried it, any problems with drivers behind you not liking it?

Highly recommend the radiantz led taillight by the way, it is way brighter than the stock bulb with the same red lens cover. 
Logged
sheets
Member
*****
Posts: 984


Jct Rte 299 & 96, Calif.


« Reply #1 on: August 06, 2013, 07:23:53 PM »

I ran a Radiantz tail light for years with a blinking (forget brand name) device wired in. Nary a problem. Numerous occasions over the years had a motorist pull up along side at a signal to let me know my brake light was blinking. That was the assurance I needed to know how effective the combination was. Some states have vehicle codes defining the use and sequence of blinking brake lights. Ya may want to verify and clarify. Its a good set up and worked for me.   
Logged
mmvalk
Member
*****
Posts: 87


Boynton Beach, FL


« Reply #2 on: August 07, 2013, 01:51:12 AM »

I use Radiantz and a Whelan TR6 and the combination is really effective - bright and noticeable!  Highly recommended!
Logged
Mr.BubblesVRCCDS0008
Member
*****
Posts: 3025

Huffman, Texas close to Houston


« Reply #3 on: August 09, 2013, 03:41:08 AM »

I use a night rider light from Custom Dynamics
Logged
Pages: [1]   Go Up
Send this topic Print
Jump to: