Valkyrie Riders Cruiser Club
July 15, 2025, 04:17:24 PM
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Homepage
:
Photostash
:
JustPics
:
Shoptalk
:
Old Tech Archive
:
Classifieds
:
Contact Staff
News
: If you're new to this message board,
read THIS!
Home
Help
Search
Login
Register
Valkyrie Riders Cruiser Club
>
General
>
1500 Tech Board
>
Can't remove my seat....
Pages: [
1
]
Go Down
« previous
next »
Author
Topic: Can't remove my seat.... (Read 644 times)
gdannar
Member
Posts: 1
Can't remove my seat....
«
on:
January 23, 2015, 01:34:40 PM »
I recently tried to remove my seat to charge my battery. The key will not turn enough to release the latch. I am afraid to break the key off in the switch. Any suggestions? Any other way to get to the seat release?
Logged
Joevalk
Member
Posts: 599
Santa Fe, Texas
Re: Can't remove my seat....
«
Reply #1 on:
January 23, 2015, 01:41:46 PM »
Push down on the front of the seat while turning the key
Logged
VRCC#32720
1999 Blk/Silver Tourer (Valkylac)
1999 Grn/Silver Interstate
1999 Blk/Silver (Texas Bobber)
http://vrcc.photostash.com/vrcc_32720/xcd%2002022.jpg
quexpress
Member
Posts: 519
Montreal, Québec, Canada
Re: Can't remove my seat....
«
Reply #2 on:
January 23, 2015, 01:45:42 PM »
If JoeValk's suggestion does not work, see Momz intructions and my latch pic at
http://www.valkyrieforum.com/bbs/index.php/topic,69380.msg676503.html#msg676503
Good luck!
Logged
I still have a full deck.
I just shuffle slower ...
cokebottle10
Member
Posts: 116
Green and Silver 99 I/S
Fletcher NC
Re: Can't remove my seat....
«
Reply #3 on:
January 23, 2015, 03:45:20 PM »
Mine did the same thing. The key would turn part way but would not unlatch. My cable was rusted. If you remove the left side cover and take out the bolts holding the radator resevior you can used a long flat screw driver to unlock the latch. Its not easy.
The cover that holds the key cylinder is not easy to get off or back on. It however very flexable. I removed my cable and shot PB blaster to free it out. Then brake clearner to clean it out. Then I used 3 in 1 oil to lube it back up. I also ordered another cable but after two years it is still working well so I have not replaced it yet.
I hope this helps,
David in Fletcher NC.
Logged
David in Fletcher NC
Pages: [
1
]
Go Up
« previous
next »
Jump to:
Please select a destination:
-----------------------------
Chapter Boards
-----------------------------
=> Texas Chapter
=> Kansas Chapter
=> Iowa Chapter
=> Florida Chapter
=> SoCal Chapter
=> Northwest Valkyrie Riders
=> British Columbia
=> New England Chapter
=> Arizona Chapter
=> South Dakota Chapter
-----------------------------
General
-----------------------------
=> General Board
=> InZane XXV
=> 1500 Tech Board
=> 1800 Tech Board
=> VRCC Members Memorial Board
=> InZanes past
=> old classifieds